Skip to content

Region AS923

If you configure a concentrator with an AS923 (sub-)region, you need to follow these steps in addition to how you would typically configure a concentrator for such a region. Since in AS923, dwell time limitations may apply, you need to be aware what the local regulations are with respect to dwell time limitations. Per default, the Network Server will assume that dwell time restrictions apply. For every concentrator in that region, you must configure the device twin to include the actual dwell time limitations that apply in the location of the concentrator. You can do this by adding the following block to the desired properties of the concentrator twin:

{
    ...,
    "properties": {
        "desired": {
            "routerConfig": { ... },
            "desiredTxParams": {
                "downlinkDwellLimit": true,
                "uplinkDwellLimit": true,
                "eirp": 5
            }
        }
    }
}

The configuration values will be translated into a TxParamSetupReq MAC command (for an explanation refer to the LoRa specification) and as such be communicated automatically to every device that connects to the concentrator, based on whether that device already responded to the TxParamSetupReq MAC command with a TxParamSetupAns. In case a device did not acknowledge such a MAC command, or if the last acknowledged TxParamSetupReq does not match the desired TX params, it will automatically send downlink MAC commands to the device until it receives a TxParamSetupAns.

Warning

If a device is associated with multiple concentrators, it's important that all of these concentrators have the same desiredTxParams properties. If they do not have the same desiredTxParams this will lead to unpredictable and unexpected behavior. Consider using Automatic IoT device and module management to manage consistent configuration between multiple concentrators.

The Network Server will apply the following effective dwell time settings in this order:

  1. If a device acknowledged a TxParamSetupReq, the Network Server will always apply dwell time settings based on the last reported properties of the device. If the last acknowledged dwell time settings (reported properties) do not match what is configured on the LoRa device, make sure to update the reported properties of the device to match the actual TX params.
  2. If a device has not yet acknowledged (or received) a TxParamSetupReq, the Network Server will apply the regional dwell time defaults (dwell time limits are on, as specified in LoRaWAN regional parameter specification) for downlink transmissions until the device acknowledges a received TxParamSetupReq MAC command.

Warning

If you associate a device with multiple Network Servers, make sure to refresh the caches (refer to the Quickstart for an explanation on how to refresh caches) of these Network Servers after the device acknowledged the updated dwell time settings.

Last update: 2022-01-06
Created: 2022-01-06
Back to top